The results reported in this paper are preliminary and constitute a prelude to a more detailed analysis of bimetallic rod rolling. In addition, the distribution of stress in the tool–workpiece contact zone may make welding of the materials difficult. The results of numerical modeling indicate that the material near the surface tends to flow, which may have a negative impact on the welding process. When the rods are heated without protective atmospheres, the surface layer of the core gets decarburized and the surfaces of the materials being joined together are oxidized, which hinders the welding process and adversely affects the physical and chemical properties of such products. However, proper fastening of the two materials depends on the geometrical parameters of the billets, and the quality of bimetallic rods depends on the heating method used. The results demonstrate that the proposed method can be successfully used in the production of bimetallic rods. During the tests, bimetallic rods were rolled from billets whose cores and outer sleeves (bushings) were made of different types of steel.
The experiments were conducted using a numerically controlled three-roller skew rolling mill. By using bimetallic strip, the error can be compensated up to a considerable extent.The present article reports selected results of a preliminary study of the process of skew rolling of bimetallic rods. Mechanical clock system is very much sensitive to temperature which results in error in operation of watch. In above figure, the bimetal is a straight strip, however it can be made in the form of a coil (as shown in figure below) to increase the length in order to increase the sensitivity of thermostat. An example of this type of thermostat is thermostat used in electric iron. Again when the temperature decrease and come back to normal condition, the bimetal comes back the normal condition and as the circuit is closed by bimetal.
#BI METAL DRAFT CONTROL FREE#
Due to which the contact attached with the free to move end of bimetallic strip moves and disconnects from fixed contact as shown in figure below. When the heat is produce this bimetallic strip bends. At normal temperature, this moving contact makes the contact with fixed contact as shown in figure below. An electrical contact is connected on free end of bimetal, which moves with the expansion and bending of bimetal. In operation as a thermostat, one end of bimetal is fixed and connected to source of supply. A typical Bimetallic thermostat for this operation is shown in figure below. In some circuits, the current passed through the thermostat itself produce the heat for operation of thermostat.
Some of these are listed below- Thermostat of Bimetalsīimetals are very much useful to make the bimetallic thermostat for automatic switching of circuit to control the temperate of certain appliance such as, Electric heater, Electric irons, refrigerators, electric ovens etc.
Alloy of iron and nickel (low “Coefficient of linear thermal expansion”) Applications of Bimetalsīimetal are having many applications.Iron, nickel, constantan (high “Coefficient of linear thermal expansion”).Some of the commonly used combinations for making bimetallic strips are listed below. Many combinations of metals with different Coefficient of linear thermal expansion can be used to form the bimetals. The above phenomenon can used to produce a useful device for detecting and measuring change in temperature.Ĭommonly Used Combinations for Making Bimetallic Strips On cooling, bimetal element bends and form an arc in such a way that the metal with lower Coefficient of linear thermal expansion is at outer side of the arc & metal with higher Coefficient of linear thermal expansion is at inner side of the arc as shown in figure below. Due to which the bimetallic element bends and form an arc in such a way that the metal with higher Coefficient of linear thermal expansion is outer at side of the arc and metal with lower Coefficient of linear thermal expansion is at inner side of the arc as shown in figure below. On heating, the expansions in the length of both metal strips are different.
0 kommentar(er)
